TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Instrument Cluster harness connector.
Disconnect the Fuel Pump Module harness connector.
Check connectors - Clean/repair as necessary.
Measure the resistance of the Fuel Level Sensor Signal circuit to ground.
Is the resistance below 10,000 (10 K) ohms? NOTE: it should be infinite.
All
Yes → Repair the Fuel Level Sensor Signal circuit for a short to the
Sensor Ground circuit.
Perform BODY VERIFICATION TEST - VER 1.
No → Test Complete.
149
INSTRUMENT CLUSTER
FUEL LEVEL SENSOR SHORT — Continued
To Next Page
Loading...
