TEST ACTION APPLICABILITY
3 Disconnect the RKE module connector.
Disconnect the interior Decklid Release Switch connector.
Measure the resistance between ground and the Decklid Release Relay Control
circuit.
Is the resistance below 1000.0 ohms?
All
Yes → Repair the Decklid Release Relay Control circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Remote Keyless Entry module.
Perform BODY VERIFICATION TEST - VER 1.
185
POWER DOOR LOCKS/RKE
INTERIOR DECKLID RELEASE SWITCH SHORTED OR STUCK —
Continued
To Next Page
Loading...
