TEST ACTION APPLICABILITY
14 Turn ignition off.
Disconnect the RKE Module connector.
Measure the resistance of the ground circuit (cavity #8) in the RKE Module
connector.
Is the resistance below 5.0 ohms?
All
Yes → Go To 15
No → Repair the open ground circuit.
Perform BODY VERIFICATION TEST - VER 1.
15 Disconnect the Remote Keyless Entry module connector.
Measure the resistance between the Driver Door Unlock Relay Output circuit and the
Door Lock Relay Output circuit in the RKE module connector..
Is the resistance LESS than 17.0 ohms?
All
Yes → Go To 16
No → Repair the open Door Lock Relay Output circuit.
Perform BODY VERIFICATION TEST - VER 1.
16 If there are no possible causes remaining, view repair. All
Repair
Replace the Remote Keyless Entry Module (relays open).
Perform BODY VERIFICATION TEST - VER 1.
195
POWER DOOR LOCKS/RKE
*ALL DOOR LOCKS INOPERATIVE — Continued
To Next Page
Loading...
