TEST ACTION APPLICABILITY
4 Remove the inner door trim panel to gain access to the Door Lock Motor connector.
Disconnect the Door Lock Motor connector.
Disconnect the Remote Keyless Entry module connector.
Measure the resistance of the Driver Door Unlock Relay Output wire between the
RKE connector and the door lock motor connector.
Is the resistance below 5.0 ohms?
All
Yes → Test Complete.
No → Repair the open Driver Door Unlock Relay Output wire.
Perform BODY VERIFICATION TEST - VER 1.
207
POWER DOOR LOCKS/RKE
*DRIVER DOOR FAILS TO LOCK & UNLOCK — Continued
To Next Page
Loading...
