TEST ACTION APPLICABILITY
4 Disconnect the Hood Ajar Switch connector.
Disconnect the Remote Keyless Entry Module connector.
Measure the resistance of the Hood Ajar Switch Sense circuit between the switch
connector and the RKE module connector.
Is the resistance below 5.0 ohms?
All
Yes → Go To 5
No → Repair the Hood Ajar Switch Sense circuit for an open.
Perform VTSS VERIFICATION TEST - 1A.
5 Disconnect the Hood Ajar Switch connector.
Connect a jumper wire between the Hood Ajar Switch Sense circuit and ground.
Does the DRBIIIt show Hood Ajar Sw: Closed?
All
Yes → Replace the Hood Ajar Switch.
Perform VTSS VERIFICATION TEST - 1A.
No → Replace the Remote Keyless Entry Module.
Perform VTSS VERIFICATION TEST - 1A.
214
VEHICLE THEFT/SECURITY
HOOD AJAR SWITCH MISSING (EXPORT ONLY) — Continued
To Next Page
Loading...
