TEST ACTION APPLICABILITY
15 Turn the ignition off.
Disconnect the CKP Sensor harness connector.
Ignition on, engine not running.
Measure the voltage on the (K7) 5 Volt Supply circuit in the CKP Sensor harness
connector.
Is the voltage above 5.5 volts?
All
Yes → Repair the short to battery voltage in the (K7) 5 Volt Supply
circuit.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
No → Go To 16
16 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
All
Repair
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
139
DRIVEABILITY - NGC
P0335-CRANKSHAFT POSITION SENSOR CIRCUIT — Continued
To Next Page
Loading...
