Dodge 2004 Neon SRT4 - Page 630

TEST ACTION APPLICABILITY
4 Disconnect the Rad Fan #1 harness connector.
Turn the ignition on.
With the DRBIIIt, actuate the High Speed Rad Fan Relay #2.
Measure the voltage of the Radiator Fan Relay Output circuit in the Radiator Fan
harness connector.
Is the voltage above 11.0 volts?
All
Yes → Replace the Radiator Fan Assembly.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
No → Go To 5
5 Turn the ignition off.
Remove the High Speed Rad Fan Relay #2 from the PDC.
Using a 12-volt test light connected toground, probe theFused B+ circuitin the PDC.
Does the test light illuminate brightly?
All
Yes → Go To 6
No → Repair the Fused B+ circuit. Inspect fuses and replace as neces-
sary.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
6 Turn the ignition off.
Remove the High Speed Rad Fan Relay from the PDC.
Disconnect the Rad Fan #1 harness connector.
Measure the resistance of the High Speed Rad Fan Relay Output circuit between the
PDC and the Radiator Fan harness connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Radiator Fan Relay.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
No → Repair the Hgih Speed Rad Fan Relay Output circuit for an open.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
294
DRIVEABILITY - NGC
*CHECKING RAD FAN HIGH SPEED OPERATION (TURBO) — Continued