EasyManua.ls Logo

Dodge 2004 Neon SRT4 - Page 760

Dodge 2004 Neon SRT4
922 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TEST ACTION APPLICABILITY
5 Turn the ignition off to the lock position.
Disconnect the PCM harness connector.
Remove the Transmission Control Relay.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between Fused B+ circuit and Transmission Control Relay
Output circuit in the Transmission Relay connector.
Ignition on, engine not running.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Using a 12-volt test light connected to ground, check the Fused B+ circuit in the
appropriate terminal of special tool #8815.
NOTE: The Test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?
All
Yes Go To 6
No Repair the Fused B+Circuit circuit for an openor high resistance.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
6 Turn the ignition off to the lock position.
Disconnect the PCM harness connector.
Remove the Transmission Control Relay.
Note: Check connectors - Clean/repair as necessary.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Connect a jumper wire between Fused B+circuit and the Transmission Control Relay
Output circuit.
Ignition on, engine not running.
Using a 12-volt test light connected to ground, check both Transmission Control
Relay Output circuits in the appropriate terminal of special tool #8815.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?
All
Yes Go To 7
No Repair the Transmission Control Relay Output circuit for an open
or high resistance.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
39
TRANSMISSION - NGC
P0562-LOW BATTERY VOLTAGE Continued

Table of Contents

Other manuals for Dodge 2004 Neon SRT4

Related product manuals