TEST ACTION APPLICABILITY
4 Turn the ignition off to the lock position.
Remove the Starter Relay.
CAUTION: Removal of the Starter Relay is to prevent a Transmission, NO
RESPONSE, condition and disable the starter.
Install the Transmission Simulator, Miller tool #8333 and the Electronic Transmis-
sion Adapter kit 8333-1A.
Ignition on, engine not running.
With the DRBIIIt, perform the Shift Lever Position Test.
When the DRBIII t instructs you to put the Gear Selector in a particular position,
you must do so using the Transmission Simulator.
The LED for the gear position in question must be illuminated on the Transmission
Simulator, prior to pressing the ENTER key on the DRBIIIt.
Did the Shift Lever Position Test pass?
All
Yes → Go To 5
No → Go To 6
NOTE: After completion of this procedure, make sure to disconnect the
Transmission Simulator, Miller tool #8333 and FWD adaptor cable kit, Miller
tool #8333-1A and reconnect all connectors.
5 If there are no possible causes remaining, view repair. All
Repair
Replace the Transmission Range Sensor per the Service Informa-
tion.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
6 Ignition on, engine not running.
With the DRBIIIt, monitor the TRS Sense circuits on the Input/Output screen - C1
thru C4.
Move the shift lever through all gear positions, pausing momentarily in each gear
position and watch for one of the circuits to not change state.
Pick the one that did not change state.
All
TRS T1 sense (C4)
Go To 7
TRS T3 sense (C3)
Go To 10
TRS T41 sense (C1)
Go To 13
TRS T42 sense (C2)
Go To 16
44
TRANSMISSION - NGC
P0706-CHECK SHIFTER SIGNAL — Continued
To Next Page
Loading...
