TEST ACTION APPLICABILITY
19 Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace the Powertrain Control Module per the Service Informa-
tion. WITH THE DRBIIIt PERFORM QUICK LEARN AND
REPROGRAM PINION FACTOR.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
20 If there are no possible causes remaining, view repair. All
Repair
Adjust the Shift Linkage and/or cable per the Service Information.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
21 The conditions necessary to set the DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wiring and connectors while checking for shorted and open circuits.
Check the Shift Linkage and cable for proper operation per the Service Information.
With the DRBIIIt, check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Perform *PRNDLFAULT CLEARING PROCEDURE after completion of any repairs.
Were there any problems found?
All
Yes → Repair as necessary.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No → Test Complete.
49
TRANSMISSION - NGC
P0706-CHECK SHIFTER SIGNAL — Continued
To Next Page
Loading...
Need help?
General
