TEST ACTION APPLICABILITY
2 With the DRBIIIt, check Transmission DTC’s.
Are there any other Transmission Temperature Sensor related DTCs present?
All
Yes → Refer to the Transmission category and perform the appropriate
symptom.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No → Go To 3
3 With the DRBIIIt, Check the STARTS SINCE SET counter for P0711.
NOTE: This counter only applies to the last DTC set.
Is the STARTS SINCE SET counter 2 or less?
All
Yes → Go To 4
No → Go To 7
4 Turn the ignition off to the lock position.
Remove the Starter Relay.
CAUTION: Removal of the Starter Relay is to prevent a Transmission, NO
RESPONSE, condition and disable the starter.
Install the Transmission Simulator, Miller tool #8333 and the Electronic Transmis-
sion Adapter kit 8333-1A.
Note: Check connectors - Clean/repair as necessary.
Ignition on, engine not running.
With the Transmission Simulator, turn the Input/Output switch to OFF.
With the DRBIIIt, monitor the TRANS TEMP VOLTS while turning the Thermistor
Voltage switch to all three positions on the Transmission Simulator.
Compare the DRBIIIt readings with the numbers listed on the Transmission
Simulator.
Do the readings on the Transmission Simulator match the DRBIIIt readings ± 0.2
volts?
All
Yes → Go To 5
No → Go To 6
5 If there are no possible causes remaining, view repair. All
Repair
Replace Transmission Solenoid/TRS assembly per the Service
Information.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
6 Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace the Powertrain Control Module per the Service Informa-
tion. WITH THE DRBIIIt PERFORM QUICK LEARN
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
51
TRANSMISSION - NGC
P0711-TRANSMISSION TEMPERATURE SENSOR PERFORMANCE —
Continued
To Next Page
Loading...
Need help?
General
