TEST ACTION APPLICABILITY
7 Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace the Powertrain Control Module per the Service Informa-
tion. WITH THE DRBIIIt PERFORM QUICK LEARN
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
8 The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wires while checking for shorted and open circuits.
With the DRBIIIt, check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Were there any problems found?
All
Yes → Repair as necessary.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No → Test Complete.
55
TRANSMISSION - NGC
P0712-TRANSMISSION TEMPERATURE SENSOR LOW — Continued
To Next Page
Loading...
Need help?
General
