TEST ACTION APPLICABILITY
2 With the DRBIIIt, read Transmission DTC’s
Are the DTC’s P0750 and/or P0841 present also?
All
Yes → Refer to the Transmission category and perform the appropriate
symptom.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No → Go To 3
3 Ignition on, engine not running.
With the DRBIIIt, record and erase DTC’s.
Drive the vehicle until it is fully warmed up. At least 110 degrees.
Perform the following step 3 times.
Drive the vehicle at 50 MPH and allow 4th gear to engage for at least 10 seconds.
Close the throttle, then tip back in until the throttle angle is between 25 and 29
degrees. Note that if you go over 30 degrees, you must back off of the throttle and
retry.
Did the TCC engage during any of the attempts?
All
Yes → Go To 4
No → Go To 5
4 The conditions necessary to set the DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wiring and connectors while checking for shorted and open circuits.
This DTC can also be set under extreme temperature conditions, this is usually
caused by an internal problem. Verify if the problem is only experienced under
extreme hot or cold conditions.
With the DRBIIIt, check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Were there any problems found?
All
Yes → Repair as necessary.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No → Test Complete.
5 If there are no possible causes remaining, view repair. All
Repair
Perform the Hydraulic Pressure test per the Service Information
and repair the internal transmission components and Torque
convertor as necessary.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
86
TRANSMISSION - NGC
P0740-TORQUE CONVERTER CLUTCH CONTROL CIRCUIT — Continued
To Next Page
Loading...
