EasyManua.ls Logo

Dodge 2004 Neon SRT4 - Page 849

Dodge 2004 Neon SRT4
922 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TEST ACTION APPLICABILITY
8 Turn the ignition off to the lock position.
Disconnect the PCM harness connector.
Remove the Transmission Control Relay.
Note: Check connectors - Clean/repair as necessary.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance between ground and the Transmission Control Relay Control
circuit.
Is the resistance below 5.0 ohms?
All
Yes Repair the Transmission Control Relay Control circuit for a short
to ground.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No Go To 9
9 Turn the ignition off to the lock position.
Disconnect the PCM harness connector.
Remove the Transmission Control Relay.
Note: Check connectors - Clean/repair as necessary.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Connect a jumper wire between the Fused B+ circuit and the Transmission Control
Relay Output circuit in the Transmission Control Relay connector.
Using a 12-volt test light connected to ground, check the Transmission Control Relay
Output circuit in the appropriate terminal of special tool #8815.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?
All
Yes Go To 10
No Replace the Transmission Control Relay.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
10 Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace the Powertrain Control Module per the Service Informa-
tion. WITH THE DRBIIIt PERFORM QUICK LEARN AND
REPROGRAM PINION FACTOR.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
128
TRANSMISSION - NGC
P0888-RELAY OUTPUT ALWAYS OFF Continued

Table of Contents

Other manuals for Dodge 2004 Neon SRT4

Related product manuals