TEST ACTION APPLICABILITY
2 Turn the ignition off.
NOTE: Perform this procedure after disconnecting each front speaker
connector.
Disconnect each front speaker harness connector one at a time.
Turn the ignition on.
Turn the radio on.
With the DRBIIIt, erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIIIt, read DTC’s.
Does the DRBIIIt display ALL OUTPUTS SHORT with all the front speakers
disconnected?
All
Yes → Go To 3
No → Replace the Speaker that when disconnected the DTC did not
reset.
Perform BODY VERIFICATION TEST - VER 1.
3 Turn the ignition off.
NOTE: Perform this procedure after disconnecting each I/P speaker con-
nector.
Disconnect each I/P speaker harness connector one at a time.
Turn the ignition on.
Turn the radio on.
With the DRBIIIt, erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIIIt, read DTC’s.
Does the DRBIIIt display ALL OUTPUTS SHORT with all the I/P speakers
disconnected?
All
Yes → Go To 4
No → Replace the Speaker that when disconnected the DTC did not
reset.
Perform BODY VERIFICATION TEST - VER 1.
4 Turn the ignition off.
NOTE: Perform this procedure after disconnecting each rear speaker
connector.
Disconnect each rear speaker harness connector one at a time.
Turn the ignition on.
Turn the radio on.
With the DRBIIIt, erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIIIt, read DTC’s.
Does the DRBIIIt display ALL OUTPUTS SHORT with all the rear speakers
disconnected?
All
Yes → Go To 5
No → Replace the Speaker that when disconnected the DTC did not
reset.
Perform BODY VERIFICATION TEST - VER 1.
84
AUDIO
ALL OUTPUTS SHORT — Continued
To Next Page
Loading...
