Setup
100 Operating Instructions 867 - 04.0 - 03/2018
To complete the short arm tabletop:
1. Screw the drawer (3) with the left-hand bracket to the under-
side of the tabletop.
2. Screw the oil pan (4) in place under the slot for the machine.
3. Screw the cable duct (5) to the underside of the tabletop.
4. Insert the reel stand (7) into the hole.
5. Assemble the reel stand (7) with nut and washer.
6. Tighten the thread reel holder and the unwinding bracket on
the reel stand (7) in such a way that they are exactly opposite
each other.
7. Insert the machine head support (1) into the hole.
8. Insert and fasten the lower hinge parts in the hinge slots (2).
9. Insert the rubber corners into the corner slots (6).
To Next Page
Loading...
