Setup
Operating Instructions 867 - 04.0 - 03/2018 119
7.12.4 Connecting the control
Connecting the control consists of the following work:
• Insert the plug of each connecting cable into the sockets on
the back of the control.
• Connect the control to the power supply using the power cable.
Operation of the control is described in the control-specific
instructions:
• Efka DC1550/DA321G control:
See accessory pack included with the control.
• DAC eco and DAC classic controls:
See accessory pack included with the control.
The instructions also available in the download area at
www.duerkopp-adler.com
Fig. 71: Connecting the control
DANGER
Risk of death from electric shock!
Unprotected contact with electricity can result in
serious injuries or death.
Disconnect the power plug before connecting the
control.
Ensure the power plug cannot be unintentionally
reinserted.
To Next Page
Loading...
