Operation
Operating Instructions 867 - 04.0 - 03/2018 21
4.3 Inserting/changing the needle
Order
After switching to a different needle thickness, adjust the distance
between hook and needle ( Service Instructions).
WARNING
Risk of injury from moving, cutting or sharp
parts!
Crushing, cutting and punctures are possible.
Switch off the machine before you insert or
change the needle.
Do not reach under the needle.
NOTICE
Property damage may occur!
Risk of missing stitches or damage to the thread or the
machine when using thinner needles. Risk of damage to the
hook tip or the needle when using thicker needles.
Correct the settings when using needles with a different
thickness.
NOTICE
Property damage may occur!
There is a risk of machine damage, needle breakage or
thread breakage if the distance between needle and hook tip
is incorrect.
Check the distance to the hook tip after inserting a needle with
a different thickness. Set the distance again if necessary.
To Next Page
Loading...
