Setup
132 Operating Instructions 867 - 04.0 - 03/2018
7.15 Performing a test run
When setup is complete, perform a test run to check the function-
ality of the machine.
Adjust the machine to the sewing material requirements.
To perform a test run:
1. Insert needle ( p. 21).
2. Wind on the hook thread, ( p. 38).
3. Insert the bobbin ( p. 41).
4. Thread hook thread ( p. 41).
5. Thread needle thread ( p. 27).
6. Set the thread tension to the sewing material being sewn
( p. 43).
7. Set the needle thread regulator to the sewing material being
sewn ( p. 49).
8. Set the sewing foot pressure to the sewing material being
sewn ( p. 54).
9. Set the sewing foot stroke to the sewing material being sewn
( p. 56).
10. Set stitch length ( p. 61).
11. Assign a function to the favorite button ( p. 66).
12. Start the sewing test at low speed.
13. Gradually increase the speed until the working speed is
reached.
WARNING
Risk of injury from moving, cutting and sharp
parts!
Crushing, cutting and punctures are possible.
Switch off the machine before you replace the
needle, insert the thread, insert the hook thread
reel, and adjust the hook thread tension and the
thread regulator.
To Next Page
Loading...
