DURKOPP ADLER 867 Durkopp Adler

Operation
38 Operating Instructions 867 - 04.0 - 03/2018
4.6 Winding the hook thread
The hook thread is normally wound on when sewing is in progress.
However, you can also wind on the hook thread without sewing,
e. g. if you require a full bobbin in order to start sewing.
To wind the hook thread:
1. Feed the hook thread properly ( p. 25).
WARNING
Risk of injury from moving, cutting or sharp
parts!
Crushing, cutting and punctures are possible.
Switch off the machine before winding the hook
thread.
NOTICE
Property damage!
Damage to the sewing feet or throat plate possible if the
thread is wound on without sewing material.
To wind on the hook thread without sewing material, set the
sewing feet to the highest position and set the sewing foot
stroke to the smallest value.

DURKOPP ADLER 867 Specifications

General

Stitch Type	Lockstitch
Max Stitch Length	12 mm
Needle System	134-35
Needle Thread Tension	Adjustable
Lubrication	Automatic
Type	Industrial Sewing Machine
Max Sewing Speed	3000 stitches per minute
Presser Foot Lift	20 mm
Power Requirements	230V/50Hz