Operation
Operating Instructions 867 - 04.0 - 03/2018 37
2. Guide the needle thread clockwise around the
pre-tensioner (12).
3. Insert the needle thread through the thread clamp (11).
4. Insert the needle thread through the two eyelets (2) and the
guide on the thread retractor (13).
5. Guide the needle thread counterclockwise around the addi-
tional tensioner (4).
6. Guide the needle thread clockwise around the main
tensioner (10).
7. Guide the needle thread around the diverter pin (9) from
above.
8. Guide the needle thread to the thread tension spring (8).
9. Lift the tightening lever (7) with the needle thread.
10. Pull the needle thread under the spring tip (6).
11. Insert the needle thread from the bottom through the thread
guide and the hole on the needle thread regulator (5).
12. Insert the needle thread from the right to the left through the
thread lever (3).
13. Feed the needle thread downward from the thread lever (3)
through the upper thread guide.
14. Feed the needle thread through the thread guide on the needle
bar.
15. Insert the needle thread through the needle eye in such a way
that the loose thread end faces the hook.
To Next Page
Loading...
Need help?
General
