Operation
Operating Instructions 867 - 04.0 - 03/2018 55
Fig. 28: Removing blocking of the adjusting wheel
To set the desired sewing foot pressure:
1. Loosen the screw (2) on the blocking element (1) using a
Phillips head screwdriver.
2. Set the sewing foot pressure.
• To increase the sewing foot pressure:
Turn the adjusting wheel (3) clockwise
• To reduce the sewing foot pressure:
Turn the adjusting wheel (3) counterclockwise
3. Tighten the blocking element (1) using the screw (2).
(1) - Blocking element
(2) - Screw
(3) - Adjusting wheel
To Next Page
Loading...
