Epson S1D13706 - Look-Up Table Registers

Epson Research and Development
Page 99
Vancouver Design Center
Hardware Functional Specification S1D13706
Issue Date: 01/11/13 X31B-A-001-08
8.3.3 Look-Up Table Registers
Note
The S1D13706 has three 256-position, 6-bit wide LUTs, one for each of red, green, and
blue (see Section 11, “Look-Up Table Architecture” on page 132).
bits 7-2 LUT Blue Write Data Bits [5:0]
This register contains the data to be written to the blue component of the Look-Up Table.
The data is stored in this register until a write to the LUT Write Address register
(REG[0Bh]) moves the data into the Look-Up Table.
Note
The LUT entry is updated only when the LUT Write Address Register (REG[0Bh]) is
written to.
bits 7-2 LUT Green Write Data Bits [5:0]
This register contains the data to be written to the green component of the Look-Up Table.
The data is stored in this register until a write to the LUT Write Address register
(REG[0Bh]) moves the data into the Look-Up Table.
Note
The LUT entry is updated only when the LUT Write Address Register (REG[0Bh]) is
written to.
bits 7-2 LUT Red Write Data Bits [5:0]
This register contains the data to be written to the red component of the Look-Up Table.
The data is stored in this register until a write to the LUT Write Address register
(REG[0Bh]) moves the data into the Look-Up Table.
Note
The LUT entry is updated only when the LUT Write Address Register (REG[0Bh]) is
written to.
Look-Up Table Blue Write Data Register
REG[08h] Write Only
LUT Blue Write Data Bits 5-0 n/a
7654321 0
Look-Up Table Green Write Data Register
REG[09h] Write Only
LUT Green Write Data Bits 5-0 n/a
7654321 0
Look-Up Table Red Write Data Register
REG[0Ah] Write Only
LUT Red Write Data Bits 5-0 n/a
7654321 0