Page 12
Epson Research and Development
Vancouver Design Center
S1D13706 Interfacing to the Motorola MC68VZ328 Dragonball Microprocessor
X31B-G-016-02 Issue Date: 01/02/26
4.2 S1D13706 Hardware Configuration
The S1D13706 uses CNF7 through CNF0 to allow selection of the bus mode and other
configuration data on the rising edge of RESET#. For details on configuration, refer to the
S1D13706 Hardware Functional Specification, document number X31B-A-001-xx.
The following table shows the configuration required for this implementation of a
S1D13706 to Motorola MC68VZ328 microprocessor.
Table 4-1: Summary of Power-On/Reset Configuration Options
S1D13706 Pin
Name
value on this pin at the rising edge of RESET# is used to configure: (1/0)
10
CNF[2:0]
110 = Dragonball Host Bus Interface
CNF3 GPIO pins as inputs at power on GPIO pins as HR-TFT / D-TFT outputs
CNF4
Big Endian bus interface Little Endian bus interface
CNF5 Active high WAIT# Active low WAIT#
CNF[7:6] see Table 4-2: “CLKI to BCLK Divide Selection” for recommended settings
= configuration for MC68VZ328 microprocessor
Table 4-2: CLKI to BCLK Divide Selection
CNF7 CNF6 CLKI to BCLK Divide
0 0 1:1
012:1
103:1
114:1
= recommended setting for MC68VZ328 microprocessor
To Next Page
Loading...