Epson S1D13706 - 3 Installation and Configuration; Configuration DIP Switches

Epson Research and Development
Page 9
Vancouver Design Center
S5U13706B00C Rev. 1.0 Evaluation Board User Manual S1D13706
Issue Date: 01/02/23 X31B-G-004-04
3 Installation and Configuration
The S5U13706B00C is designed to support as many platforms as possible. The
S5U13706B00C incorporates a DIP switch and seven jumpers which allow both evaluation
board and S1D13706 LCD controller to be configured for a specified evaluation platform.
3.1 Configuration DIP Switches
The S1D13706 has configuration inputs (CNF[7:0]) which are read on the rising edge of
RESET#. In order to configure the S1D13706 for multiple Host Bus Interfaces a ten-
position DIP switch (S1) is required. The following figure shows the location of DIP switch
SW1 on the S5U13706B00C.
Figure 3-1: Configuration DIP Switch (SW1) Location
DIP Switch - SW1