Epson S1D13706 - 3 S1 D13706 Host Bus Interface; Host Bus Interface Pin Mapping

Page 10
Epson Research and Development
Vancouver Design Center
S1D13706 Interfacing to the NEC VR4102 / VR4111 Microprocessors
X31B-G-007-02 Issue Date: 01/02/23
3 S1D13706 Host Bus Interface
The S1D13706 directly supports multiple processors. The S1D13706 implements a 16-bit
Generic #2 Host Bus Interface which is most suitable for direct connection to the NEC
VR4102/4111 microprocessor. Generic #2 supports an external Chip Select, shared
Read/Write Enable for high byte, and individual Read/Write Enable for low byte.
The Generic #2 Host Bus Interface is selected by the S1D13706 on the rising edge of
RESET#. After RESET# is released, the bus interface signals assume their selected config-
uration. For details on the S1D13706 configuration, see Section 4.2, “S1D13706 Hardware
Configuration” on page 13.
3.1 Host Bus Interface Pin Mapping
The following table shows the functions of each Host Bus Interface signal.
Table 3-1: Host Bus Interface Pin Mapping
S1D13706
Pin Names
NEC VR4102/4111
AB[16:0] ADD[16:0]
DB[15:0] DAT[15:0]
WE1# SHB#
CS# LCDCS#
M/R# ADD17
CLKI BUSCLK
BS# connect to HIO V
DD
RD/WR# connect to HIO V
DD
RD# RD#
WE0# WR#
LCDRDY WAIT#
RESET# system RESET