Epson S1D13706 - Page 308

Page 4
Epson Research and Development
Vancouver Design Center
S1D13706 13706BMP Demonstration Program
X31B-B-004-02 Issue Date: 01/02/23
Usage
At the prompt, type:
13706bmp bmpfile1 [bmpfile2] [ds=n | ds=?] [move=n] [/noinit] [/r90 | /r180 | /r270]
[/v] [/?]
Where:
bmpfile1 Specifies filename of the windows format bmp image used
for the main window (display surface 0).
bmpfile2 Specifies filename of the windows format bmp image used
for the sub-window (display surface 1). If bmpfile2 is
not specified, bmpfile1 is also used for the sub-window.
ds=n Selects display surfaces (see Section , “Display Surfaces”
on page 5).
ds=? Shows available display surfaces (see Section , “Display
Surfaces” on page 5).
move=n Automatically moves the sub-window for n seconds. To
move the sub-window indefinitely set n=-1.
/noinit Skips full register initialization. Only registers used for
changing the color depth (bpp) are updated.
Additionally, some registers are read to determine infor-
mation such as display size.
/r90 Enables SwivelView 90° mode, counter-clockwise
hardware rotation of the LCD image by 90 degrees.
/r180 Enables SwivelView 180° mode, counter-clockwise
hardware rotation of the LCD image by 180 degrees.
/r270 Enables SwivelView 270° mode, counter-clockwise
hardware rotation of the LCD image by 270 degrees.
/v Verbose mode (provides information about the displayed
image).
/? Displays the help message.
Note
13706BMP displays the bmpfile image(s) and returns to the prompt.