Epson Research and Development
Page 13
Vancouver Design Center
Windows® CE 2.x Display Drivers S1D13706
Issue Date: 01/05/25 X31B-E-001-04
A WinCE desktop application (or control panel applet) can change these registry values,
and the display driver will select a different mode upon warmboot. This allows the display
driver to support different display configurations and/or orientations. An example appli-
cation that controls these registry values will be made available upon the next release of the
display driver; preliminary alpha code is available by special request.
Comments
• The display driver is CPU independent, allowing use of the driver for several Windows
CE Platform Builder supported platforms.
• By default, the 13706CFG program assumes PCI addressing for the S5U13706B00C
evaluation board. This means that the display driver will automatically locate the
S1D13706 by scanning the PCI bus (currently only supported for the CEPC platform). If
you select the address option “Other” and fill in your own custom addresses for the
registers and video memory, then the display driver will not scan the PCI bus and will
use the specific addresses you have chosen.
• When using 13706CFG.EXE to produce multiple MODE tables, make sure you change
the Mode Number in the WinCE tab for each mode table you generate. The display
driver supports multiple mode tables, but only if each mode table has a unique mode
number.
• At this time, the drivers have been tested on the x86 CPUs and have been run with
version 2.0 of the ETK, Platform Builder v2.1x.
To Next Page
Loading...
