Epson Research and Development
Page 5
Vancouver Design Center
Wind River WindML v2.0 Display Drivers S1D13706
Issue Date: 01/04/06 X31B-E-002-03
Note
Mode0.h should be created using the configuration utility 13706CFG. For more infor-
mation on 13706CFG, see the 13706CFG Configuration Program User Manual, docu-
ment number X31B-B-001-xx available at www.erd.epson.com.
6. Build the WindML v2.0 library.
From a command prompt change to the directory “x:\Tornado\host\x86-win32\bin”
and run the batch file torvars.bat. Next, change to the directory “x:\Tornado\tar-
get\src\ugl” and type the command:
make CPU=PENTIUM ugl
7. Open the S1D13706 workspace.
From the Tornado tool bar, select File->Open Workspace...->Existing->Browse... and
select the file “x:\13706\8bpp\13706.wsp” (or “x:\13706\16bpp\13706.wsp”).
8. Add support for single line comments.
The WindML v2.0 display driver source code uses single line comment notation, “//”,
rather than the ANSI conventional comments, “/*...*/”.
To add support for single line comments follow these steps:
a. In the Tornado “Workspace Views” window, click on the “Builds” tab.
b. Expand the “8bpp Builds” (or “16bpp Builds”) view by clicking on the “+”
next to it. The expanded view will contain the item “default”. Right-click on
“default” and select “Properties...”. A “Properties:” window will appear.
c. Select the “C/C++ compiler” tab to display the command switches used in
the build. Remove the “-ansi” switch from the line that contains “-g
-mpentium -ansi -nostdinc -DRW_MULTI_THREAD”.
(Refer to GNU ToolKit user's guide for details)
9. Compile the VxWorks image.
Select the “Builds” tab in the Tornado “Workspace Views” window.
Right-click on “8bpp files” (or “16bpp files”) and select “Dependencies...”. Click on
“OK” to regenerate project file dependencies for “All Project files”.
Right-click on “8bpp files” (or “16bpp files”) and select “ReBuild All(vxWorks)” to
build VxWorks.
10. Copy the VxWorks file to the diskette.
From a command prompt or through the Windows interface, copy the file
“x:\13706\8bpp\default\vxWorks” (or “x:\13706\16bpp\default\vxWorks”) to the
bootable disk created in step 4.
11. Start the VxWorks demo.
Boot the target PC with the VxWorks bootable diskette to run the UGL demo program
automatically.
To Next Page
Loading...
