Epson S1D13706 - Page 395

Epson Research and Development
Page 19
Vancouver Design Center
S5U13706B00C Rev. 1.0 Evaluation Board User Manual S1D13706
Issue Date: 01/02/23 X31B-G-004-04
Note
1
When dip switch SW1-4 is open (CNF3 = 0 at RESET#), GPIO[6:0] are at low output
states after reset. If REG[10h] bits[1:0] are set for either HR-TFT or D-TFD, some of
the pins are used for the HR-TFT or D-TFD interfaces and are not available as GPIO
pins.
Table 5-2: Extended LCD Signal Connector (H2)
Pin
Name
Connector
Pin No.
Monochrome
Passive Panel
Color Passive Panel Color TFT Panel
Single
Single
Others
HR-
TFT
1
D-TFD
1
Format 1 Format 2
4-bit 8-bit 4-bit 8-bit 8-bit 16-Bit 9-bit 12-bit 18-bit 18-bit 18-bit
GPIO0 1 GPIO0 PS XINH
GPIO1 3 GPIO1 CLS YSCL
GPIO2 5 GPIO2 REV FR
GPIO3 7 GPIO3 SPL FRS
GPIO4 9 GPIO4 GPIO4 RES
GPIO5 11 GPIO5 GPIO5 DD_P1
GPIO6 13 GPIO6 GPIO6 YSCLD
CVOUT 15 CVOUT
GND
2, 4, 6, 8, 10,
12, 14, 16
GND