Page 126
Fire Alarm Computer 8000C / M
Wiring of the terminal card
The signal to enable the fire service key box (FSKB)is activated when the master box
acknowledge signal (terminal 8 = MFAB acknowledge) from the fire alarm control panel is
detected.
Optical displays of the master box
An activated master box can be identified by a steadily lit red LED Main Detector (MFAB) on the
control panel of the fire alarm control panel. Intervening personnel such as the fire department
have been notified.
If it has been impossible to activate a master box due to an event, possibly because the MFAB
was switched off, this is indicated on the control panel by the steadily lit red LED Notify fire
department.
aster box activation module
MFAB reset (+12V or +24V/300mA)
primary loop to MFAB (+MFAB)
unlock fire department box (switched to GND max. 300mA)
(schematic circuit diagram)
1
2
3
4
5
6
7
8
(schematic circuit diagram)
To Next Page
Loading...
