evertz 3025EMC - Eas

3025EMC Master Control Switching & Channel Branding
Page 108 Revision 3.0.3
User ID: Enter a user ID name in this field. This is the user id required to log into the
network attached storage. This is typically provided by the local IT administrator.
Group ID: Enter a group ID name in this field. This is the group id required to login into
network attached storage. This is typically provided by the local IT administrator.

NOTE: The (+NAS) option is required to use Network Attached Storage.

IMPORTANT: A name MUST be provided for the NAS device to enable NAS. After
configuration upload to the EMC, wait for approximately 2 minutes then reboot
the 3025EMC.
4.18. EAS
This section configures the Emergency Alert System (+E) option. The +E option is only available in
North America. A typical system would use an EAS device externally to the EMC. The EAS device will
send the EAS alert text over a serial or IP interface based on the device. This tab configures the
properties of the EAS crawl itself. To set up an EAS system, please refer to section 8.2.1.