evertz 3025EMC - Switching Reference; Control; General Purpose Inputs;Outputs; LTC Reader

3025EMC Master Control Switching & Channel Branding
Page 212 Revision 3.0.3
Connectors: DIN 1.0/2.3 or BNC per IEC 61169-8 Annex A
9.8.2. Switching Reference
Reference Input: Analog 525/625 or Tri-level
Signal Level: 1V p-p ±3dB
Connector: DIN 1.0/2.3 or BNC per IEC 61169-8 Annex A
9.8.3. Control
Q-Link: DIN 1.0/2.3 or BNC per IEC 61169-8 Annex A
Serial: 6 serial (3 RS-232/3 RS-422)
DB9 female (on two breakout panels)
Ethernet: Dual 10/100/1000BT, 8-pin RJ45
9.8.4. General Purpose Inputs/Outputs
Inputs: 16 (standard)
Outputs: 16 (standard)
Type: Opto-isolated, active low
Connector: Terminal block (on breakout panel)
9.8.5. LTC Reader
Standard: SMPTE 12M-1
Frame Rate: 25 and 30 Fps nominal
Connectors: 3-pin female XLR type connector (on breakout panel)
Level: 0.2V to 4V p-p, balanced or unbalanced
9.8.6. Physical (EMX6-FR)
Height: 10.5” (266 mm)
Weight: 19” (483 mm)
Depth: 14.5” (368 mm)
Module: 15 single slot modules
Weight: Approx. 17.4lbs (7.9kg) with 2 power supplies, no slots occupied
Approx. 32lbs (14.5kg) with 2 power supplies, all slots occupied
9.8.7. Physical (EMX3-FR)
Height: 5.25” (133mm)
Width: 19” (483mm)
Depth: 15.75” (400mm)
Module: 5 single slot modules
9.8.8. Electrical (EMX6-FR)
AC Mains Input: Auto ranging, 100 – 200 V AC, 50/60 Hz
Max. Oper Current: 9.5A (@115V AC nominal)
4.0A (@220V AC nominal)
Single Channel: Approx. 90W