evertz 3025EMC - UP MIX Routing

3025EMC Master Control Switching & Channel Branding
Page 82 Revision 3.0.3
4.11.2.1. Intelligain Options
Module: Select in the drop-down menu if routing for intelligain module 1 (8 channels) or
module 2 is being configured.
Enable: Intelligain module Enabled/Disabled.
Source Input Bus: Select which output bus the audio channels for the Intelligain module will be
coming from. Possible options are Program, Clean and Aux. Selecting Preset is
INVALID.
Input Group: Each IntelliGain block applies the Intelligain setting to 8 sequential channels at
any time. Use this setting to configure which 8 channels will have Intelligain
applied.
Destination: Configure to which output bus and channels the audio channels from the
Intelligain module will be routed to.
The Intelligain parameters are configured directly on the 3025AP (audio processing) module. Refer to
the 3025AP for more details on this configuration.
4.11.3. UP MIX Routing
To enable the Up Mix routing on the 3025EMC (requires the +UMX option on the 3025AP audio
processing board) the Up Mix checkbox in the Additional Options dialogue of the Audio Processing
Tab of the 3025EMC channel configuration MUST be checked.
4.11.3.1. Up Mix Options
Module: Select in the drop-down menu if routing for upmixing module 1 (2 input channels
and 6 output channels) or module 2 is being configured.
Enable: Up Mix module is Enabled/Disabled.
Source Input Bus: Similar to the Dolby-E decoders, the Up Mix modules are located at the input of
the 3025EMC audio path. Normal operation would be to configure module 1 to be
in the PGM path and module 2 to be in the PST path.
Input Pair: Configure (for each module) which audio channel pair will be routed to the input
channels of the Up Mix processing block.
Output Pair: Configure (for each module) to which audio channels the output of the Up Mix
processing block (six channels) will be routed. These should be the same for
module 1 and module 2.