evertz 3025EMC - Markets; Table 7-3: Macro Events

3025EMC Master Control Switching & Channel Branding
Page 160 Revision 3.0.3
Dolby Encoder On
Take a Dolby Encoder On-
Air
Encoder Number
None
Dolby Encoder Off
Take a Dolby Encoder Off-
Air
Encoder Number
None
Dolby Encoder Level On
Set a Dolby Encoder to be
On-Air after the next
transition
Encoder Number
None
Dolby Encoder Level Off
Set a Dolby Encoder to be
Off-Air after the next
transition
Encoder Number
None
GPO Trigger
Trigger an EMC GPO.
EMC GPO must be
configured as “GPO
SYSTEM EVENT”.
Parameter 1 is always 4
and Parameter 2 is the
active length in frames.
GPO Number
None.
Dolby Encoder Auto On
Enable the Dolby-E
Encoder On/Off auto-detect
functionality.
Encoder Number and Bus
None
Dolby Encoder Auto Off
Disable the Dolby-E
Encoder On/Off auto-detect
functionality.
Encoder Number and Bus
None
Soft Reset
Perform a soft reset of the
channel from the panel.
Must be in Emergency
Mode OR Just do it with no
safeguard.
None
Run GPI Script
Run a pre-configured GPI
script
Open 1-15 or Closed 1-15
None
UDX Level ON
Set the Level ON for Up
Mix, Down Mix 1 or Down
Mix 2.
Up Mix, Down Mix 1 or
Down Mix 2.
None
UDX Level OFF
Set the Level OFF for Up
Mix, Down Mix 1 or Down
Mix 2.
Up Mix, Down Mix 1 or
Down Mix 2.
None
UDX On-Air
Set On-Air for Up Mix,
Down Mix 1 or Down Mix 2.
Up Mix, Down Mix 1 or
Down Mix 2.
None
UDX Off-Air
Set Off-Air for Up Mix,
Down Mix 1 or Down Mix 2.
Up Mix, Down Mix 1 or
Down Mix 2.
None
Table 7-3: Macro Events
7.4. MARKETS
The 3025EMC offers a feature called Markets. This feature is typically used in multi-channel systems to
group similar channels together. Markets allow the user to control multiple channels at once. This is
useful for manually operating a simulcast.

Note: Automation systems can NOT control markets. Markets are only available
for manual operation.