3025EMC Master Control Switching & Channel Branding
Page 32 Revision 3.0.3
4. EMC CONFIGURATION SOFTWARE
This section describes the software used to configure the 3025EMC switcher. Every 3025EMC is
supplied with the EMC-Setup software, which is a Windows PC configuration tool. The following screens
were taken from version 5.00.111c of EMC-Setup software.
Figure 4-1: Main EMCSetup Screen
The version number of the setup application software can be found by selecting “Help”
then “About EMCSetup”.
The opening screen is broken down into the three major pieces that are required for an EMC system.
These sections are:
• Mixer Channels – The configuration of all the EMC channels in the overall system. Each
channel is added individually in this list.
• Sources – The source name table of the upstream router used in the system to feed video/audio
to the EMC channels. This is a global nametable that ALL EMC channels in the system will use.
• Panels – The configuration of the various switcher control panels used in the system to control
the channels defined in the Mixer Channels section.
EMC-Setup will create a configuration file that describes the whole EMC system. This section will
describe how to configure a basic configuration similar to Figure 3-1.
To Next Page
Loading...