evertz 3025EMC - Page 172

3025EMC Master Control Switching & Channel Branding
Page 158 Revision 3.0.3
Function
Description
Argument
Parameter
DVE-A Move on PGM
Select a Primary DVE move
on Program Bus
DVE Move 1 to 64 None
DVE-B Move on PGM
Select a Secondary DVE
move on Program Bus
DVE Move 1 to 64
None
DVE-A Move on PVW
Select a Primary DVE move
on Preset Bus
DVE Move 1 to 64
None
DVE-B Move on PVW
Select a Secondary DVE
move on Preset Bus
DVE Move 1 to 64
None
DVE Priority
Set the priority of the DVE
Move if Primary and
Secondary are used. The
highest priority will be on
top.
DVE-A is highest, DVE-B is
highest
None
DVE-A Off-air
Take Primary DVE move
Off Air.
None
None
DVE-B Off-air
Take Secondary DVE move
Off Air.
None
None
DVE-A Transitional
This puts the Primary DVE
move in a transitional state.
None
None
DVE-B Transitional
This puts the Secondary
DVE move in a transitional
state.
None
None
DVE OFF
DVE A PGM
Remove Primary DVE from
PGM.
None
DVE A PVW
Remove Primary DVE from
PST.
DVE B PGM
Remove Secondary DVE
from PGM.
DVE B PVW
Remove Secondary DVE
from PST.
ALL PGM
Remove ALL active DVEs
from PGM.
ALL PVW
Remove ALL active DVEs
from PST.
ALL DVE
Remove ALL active DVEs
from both PGM & PST.
Extended Audio On Air
Not Supported.
Extended Audio Off Air
Not Supported.
Keyer On Air
Take the Keyer layer On Air
KEY-1, KEY-2, KEY-3,
KEY-4
None
Keyer Off Air
Take the Keyer layer Off Air
KEY-1, KEY-2, KEY-3,
KEY-4
None
Select Logo
Not Supported
Voice-overs On Air
Take the Voice Over layer
On Air
SO-1, SO-2, SO-3, SO-4,
SO-5
None