3025EMC Master Control Switching & Channel Branding
Page 52 Revision 3.0.3
Please note: Discrete AES for Program, Preset, Emergency and Voiceovers 3, 4
& 5 requires additional hardware. Contact factory for more information.
The 3025EMC has 3 16 channel fixed de-embedders, one each for the Program, Preset and
Emergency Inputs.
In addition to the Program, Preset and Emergency de-embedders there are also 5 additional 16
channels de-embedders that can be assigned by the user.
For VO1 (Voice-over 1) and VO2 (Voice-over 2), there are four options for the audio source for each of
the VO1 and VO2 buses. The options for the other buses vary depending on the VO selected.
Voiceover 1
AES: This configures the EMC to use the discrete AES audio that is connected to MADI
inputs 1 and 2. For more details see section 2.9.3.
AES AP: This configures the EMC to use the discrete AES audio that is connected to AES inputs
1 and 2 of the 3025AP module. This is required because the EMC MADI inputs 1 and 2
are being used as MADI receivers for the 3025AP interface.
Embedded: This configures the voiceover 1 bus to use de-embedded audio from a serial video
input. When this is configured the “De-embedder Source” drop-down menu becomes
available. Any of Key1, Fill1, Key2, Fill2, Key3, Fill3, Aux1, Aux2, Aux3, DVE1 and
DVE2 can be assigned to the voiceover 1 de-embedder.
AES MADI: This configures the 3025EMC to use discrete audio that is connected to the
corresponding inputs on the 3025EMC-48x36-AES audio module.
Voiceover 2
AES: This configures the EMC to use the discrete AES audio that is connected to MADI
inputs 3 and 4. For more details see section 2.9.3.
AES AP: This configures the EMC to use the discrete AES audio that is connected to AES inputs
3 and 4 of the 3025AP module. This is required because the EMC MADI inputs 3 and 4
are being used as MADI receivers for the 3025AP interface.
Embedded: This configures the voiceover 2 bus to use de-embedded audio from a serial video
input. When this is configured the “De-embedder Source” drop-down menu becomes
available. Any of Key1, Fill1, Key2, Fill2, Key3, Fill3, Aux1, Aux2, Aux3, DVE1 and
DVE2 can be assigned to the voiceover 2 de-embedder.
AES MADI: This configures the 3025EMC to use discrete audio that is connected to the
corresponding inputs on the 3025EMC-48x36-AES audio module.
To Next Page
Loading...
