3025EMC Master Control Switching & Channel Branding
Page 58 Revision 3.0.3
4.5.3.7. Allow Phase 'Invert Left' with Auto Phase Correction
Not supported.
4.5.3.8. Allow Change To and From VO Shuffle 'None'
Not supported.
4.5.3.9. Manual Hot Cut Does Not Affect On-Air Voice Overs
A manual Hot Cut on the PGM bus normally forces any On-Air or Preset Voice Over to the off
condition. When ticked this option allows the On-Air Voice Over to remain on during Hot Cuts but
Preset VO's are forced to the off state. This control only affects manual Hot Cuts on the PGM bus.
For automation Hot Cuts an On-Air voice over remains On-Air but is preset ready to come Off-Air at
the next transition. Automation Hot Cut control of voice overs can be disabled by settings the GVG
M2100 Protocol Data Byte to 1.
4.5.3.10. Enable VO On Air Requests During Transitions
During a transition changes and to any item that could be part of the transition are blocked, including
applying and removing Voice Overs. When ticked this option will allow a Voice Over to be applied or
removed during a transition providing the transition does not already have the same Voice Over active.
This can be useful in Voice Over booths where the operator will press a button (connected to EMC GPI
input) to activate a Voice Over but may do this during other automation driven transitions.
To Next Page
Loading...
