FibroLAN Falcon-MX User Manual

Falcon M-Class | User Guide
138
4.10.1.6 Access Management Configuration
In this subsection, you may configure the access management configuration.
The maximum number of entries is 16. If the application's type match any one of the access
management entries, it will allow access to the switch.
Figure 4-76: Access Management Configuration display
Table 4-73: Access Management Configuration parameters
Mode
Indicates the access management mode operation. Possible modes are:
Enabled: Enable access management mode operation.
Disabled: Disable access management mode operation.
Delete
Check to delete the entry. It will be deleted during the next save.
VLAN ID
Indicates the VLAN ID for the access management entry.
Start IP address
Indicates the start IP address for the access management entry
End IP address
Indicates the end IP address for the access management entry.
HTTP/HTTPS
Indicates that the host can access the switch from HTTP/HTTPS
interface if the host IP address matches the IP address range provided
in the entry.
SNMP
Indicates that the host can access the switch from SNMP interface if the
host IP address matches the IP address range provided in the entry
TELNET/ SSH
Indicates that the host can access the switch from TELNET/SSH
interface if the host IP address matches the IP address range provided
in the entry.
Buttons
Add New Entry: Click to add a new access management entry.
Save : Click to save change
Reset : Click to undo any changes made locally and revert to previously
saved values

FibroLAN Falcon-MX Specifications

General

Brand	FibroLAN
Model	Falcon-MX
Category	Switch
Language	English