EasyManuals Logo

FibroLAN Falcon-MX User Manual

Default Icon
473 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
Falcon M-Class | User Guide
99
Port Shaper
Enable
Controls whether the port shaper is enabled for this switch port.
Port Shaper
Rate
Controls the rate for the port shaper. The default value is 500. This value
is restricted to 100-1000000 when the "Unit" is "kbps", and it is restricted
to 1-3300 when the "Unit" is "Mbps".
Port Shaper
Unit
Controls the unit of measure for the port shaper rate as "kbps" or "Mbps".
The default value is "kbps".
Buttons
Save:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved
values.
Cancel: Click to undo any changes made locally and return to the
previous page.
4.8.5 QoS Egress Port Shapers
This page provides an overview of QoS Egress Port Shapers for all switch ports.
This section provides an overview of QoS Egress Port Shapers for all switch ports.
Figure 4-52: QoS Egress Port Shapers display
Table 4-50: QoS EgressPort Shapers parameters
Port
The logical port for the settings contained in the same row.
Click on the port number in order to configure the shapers.
Qn
Shows "-" for disabled or actual queue shaper rate - e.g. "800
Mbps".
Port
Shows "-" for disabled or actual port shaper rate - e.g. "800
Mbps".
By clicking on any port number in the above table, you may access another display, which will allow
configuring the QoS Egress Scheduler and Shapers for a specific port.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FibroLAN Falcon-MX and is the answer not in the manual?

FibroLAN Falcon-MX Specifications

General IconGeneral
BrandFibroLAN
ModelFalcon-MX
CategorySwitch
LanguageEnglish

Related product manuals