Falcon M-Class | User Guide
98
Figure 4-51: QoS Egress Port Schedulers and Shapers
Table 4-49: QoS Egress Port Schedulers and Shapers Parameters
Controls whether the scheduler mode is "Strict Priority" or "Weighted"
on this switch port.
Controls whether the queue shaper is enabled for this queue on this
switch port.
Controls the rate for the queue shaper. The default value is 500. This
value is restricted to 100-1000000 when the "Unit" is "kbps", and it is
restricted to 1-3300 when the "Unit" is "Mbps".
Controls the unit of measure for the queue shaper rate as "kbps" or
"Mbps". The default value is "kbps".
Controls whether the queue is allowed to use excess bandwidth.
Controls the weight for this queue. The default value is "17". This value is
restricted to 1-100. This parameter is only shown if "Scheduler Mode" is
set to "Weighted".
Shows the weight in percent for this queue. This parameter is only shown
if "Scheduler Mode" is set to "Weighted".
To Next Page
