FibroLAN Falcon-MX User Manual

Falcon M-Class | User Guide
22
3.2.1 Initial Configuration
This first configuration is done via the console; it enables the switch to connect to the IP network..
Once the unit IP address is set via console, the system can be accessed through Web, Telnet or any
other management options.
Initial IP setup can be implemented by manually setting the IP address Parameters or by an
automatic DHCP setup (if a DHCP server is present).
Both setup procedures may be implemented via the following CLI IP
configuration commands:
Falcon# config terminal
Falcon(config)# ip ?
example: Falcon(config)# ip routing
arp
Address Resolution Protocol
dhcp
Dynamic Host Configuration Protocol
dns
Domain Name System
domain
IP DNS Resolver
helper-address
DHCP relay server
http
Hypertext Transfer Protocol
igmp
Internet Group Management Protocol
multicast
IPv4/IPv6 multicast configuration
name-server
Domain Name System
route
Add IP route
routing
Enable routing for IPv4 and IPv6
source
source command
ssh
Secure Shell
verify
verify command
3.2.2 Web management initial display
The Web management is accessed by setting the required IP address in the URL Browser.
When accessing the devices via the Web interface, its initial Port State Overview window is
displayed. as shown below.

FibroLAN Falcon-MX Specifications

General

Brand	FibroLAN
Model	Falcon-MX
Category	Switch
Language	English