FibroLAN Falcon-MX - System Log Configuration

Falcon M-Class | User Guide
34
4.3.7 System Log Configuration
Configure System Log on this section
Figure 4-10: System Log Configuration displays
Table 4-9: System Log Configuration Parameters
System Log Configuration
Server M ode
Indicates the server mode operation
When the mode operation is enabled, the syslog message will
send out to syslog server.
The syslog protocol is based on UDP communication and
received on UDP port 514 and the syslog server will not send
acknowledgments back sender since UDP is a connectionless
protocol and it does not provide acknowledgments.
The syslog packet will always send out even if the syslog server
does not exist. Possible modes are:
Enabled: Enable server mode operation.
Disabled: Disable server mode operation.
Server Address
Indicates the IPv4 host address of syslog server. If the switch
provide DNS feature, it also can be a domain name.
Syslog Level
Indicates what kind of message will send to syslog server.
Possible modes are:
Error: Send the specific messages which severity code is less
or equal than Error(3).
Warning: Send the specific messages which severity code is
less or equal than Warning(4).
Notice: Send the specific messages which severity code is less
or equal than Notice(5).
Informational: Send the specific messages which severity
code is less or equal than Informational(6).
Buttons
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to
previously saved values.