FibroLAN Falcon-MX - Dying Gasp Configuration

Falcon M-Class | User Guide
35
4.3.8 Dying Gasp Configuration
This section configures dying gasp parameters.
Figure 4-11: Dying Gasp Configuration
Table 4-10: Dying Gasp Configuration Parameters
System Log Configuration
Port
Select the port to which the Dying Gasp is applied
Mode
Enable or disable dying gasp functionality for a port
Frame Type
Select the sending frame format during dying gasp.
SNMP or Link OAM
Tx Frames
Indicates the number of frames to transmit during dying gasp
Tx Frames can be set between 1 to 5 frames
Buttons
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to
previously saved values.
Refresh:
Click to refresh the screen; any changes made locally will be
undone
Auto-refresh : Check this box to refresh the page
automatically. Automatic refresh occurs every 3 seconds