Copying 169
Making Copies From the DADF
IMPORTANT:
• Do not load more than 50 sheets into the DADF or allow more than 50 sheets to be fed to the document output tray. The
document output tray should be emptied before it exceeds 50 sheets or your original documents may be damaged.
NOTE:
• To get the best scan quality, especially for gray scale images, use the document glass instead of the DADF.
• A computer connection is not required for copying.
• You cannot load the following documents in the DADF. Be sure to place them on the document glass.
To make a copy from the DADF:
1 Load the documents face up on the DADF with top edge of the documents in first. Then adjust the document
guides to the correct document size. To simply make a copy without changing the default copy settings,
proceed to step 4.
NOTE:
• Ensure that you use the document guides before copying a legal-size document.
2 Customize the copy settings including the copy size, contrast, and image quality.
See also:
• "Setting Copy Options" on page 170
To clear the settings, use the CA (Clear All) button.
NOTE:
• The copy options automatically return to their default status after the auto clear timer is expired.
3 Enter the number of copies from 1 to 99 using the number pad.
4 Press the (Start) button to begin copying.
NOTE:
• Press the (Stop) button to cancel a copy job at any time while scanning and printing a document.
Curled originals Pre-punched paper
Lightweight originals Folded, creased or torn originals
Cut and paste originals Carbon paper
To Next Page
Loading...
Need help?
General
