308 Using the Operator Panel Menus and Keypad
Panel Lock Function
This feature prevents unauthorized users from changing settings made by the administrator. However, you can
select settings for individual print jobs using the print driver.
This section includes:
• "Enabling the Panel Lock" on page 308
• "Disabling the Panel Lock" on page 308
NOTE:
• Disabling the operator panel menus does not prevent access to the Secure Print, Sample Print and Tray Settings
menus.
Enabling the Panel Lock
1 Press the (System) button.
2 Select Admin Menu, and then press the button.
3 Select Secure Settings, and then press the button.
4 Select Panel Lock, and then press the button.
5 Select Panel Lock Set, and then press the button.
6 Select Enable, and then press the button.
7 Enter the new password, and then press the button.
8 Re-enter the password to confirm the password that you entered, and then press the button.
NOTE:
• The factory-default panel password is 0000.
• Be sure to remember the password. The procedure described below allows you to reset the password, but the settings for
Address Book are cleared.
• Turn off the printer. Then, while holding the
(System) button, turn on the printer.
• If you change the password while Panel Lock Set is Enable, perform steps 1 to 2. Enter the current password, and then
press the button. Perform steps 3 to 4. Select Change Password, and then press the button. Enter the current
password, and then press the button. Perform steps 7 and 8. This will change the password.
Disabling the Panel Lock
1 Press the (System) button.
2 Select Admin Menu, and then press the button.
3 Enter the password, and then press the button.
4 Select Secure Settings, and then press the button.
5 Select Panel Lock, and then press the button.
6 Select Panel Lock Set, and then press the button.
7 Select Disable, and then press the button.
8 Enter the current password, and then press the button.
To Next Page
Loading...
