Fuji Xerox DocuPrint M355 df - Alert Tone

Using the Operator Panel Menus and Keypad 277
• Alert Tone
Purpose:
To configure settings for tones emitted by the printer during operation or when a warning message appears.
Values:
Panel Select Tone Off
*
Does not emit a tone when the operator panel entry is correct.
Soft Emits a tone when the operator panel entry is correct.
Normal
Loud
Panel Alert Tone Off
*
Does not emit a tone when the operator panel entry is incorrect.
Soft Emits a tone when the operator panel entry is incorrect.
Normal
Loud
Machine Ready
Tone
Off Does not emit a tone when the printer is ready to process a job.
Soft Emits a tone when the printer is ready to process a job.
Normal
*
Loud
Copy Job Tone Off Does not emit a tone when a copy job is complete.
Soft Emits a tone when a copy job is complete.
Normal
*
Loud
Non-Copy Job
Tone
Off Does not emit a tone when a job other than a copy job is complete.
Soft Emits a tone when a job other than a copy job is complete.
Normal
*
Loud
Fault Tone Off Does not emit a tone when a job ends abnormally.
Soft Emits a tone when a job ends abnormally.
Normal
*
Loud
Alert Tone Off Does not emit a tone when a problem occurs.
Soft Emits a tone when a problem occurs.
Normal
*
Loud
Out of Paper Off Does not emit a tone when the printer runs out of paper.
Soft Emits a tone when the printer runs out of paper.
Normal
*
Loud
Low Toner Off Does not emit a tone when a toner is low.
Soft Emits a tone when a toner is low.
Normal
*
Loud
Auto Clear Alert Off
*
Does not emit a tone 5 seconds before the printer performs auto
clear.
Soft Emits a tone 5 seconds before the printer performs auto clear.
Normal
Loud