Fuji Xerox DocuPrint M355 df - Power Saver Timer; Power Saver Wake up

Using the Operator Panel Menus and Keypad 275
• Adobe Protocol
Purpose:
To specify PostScript communication protocol. You can configure the Adobe Protocol settings for the wired
network. The change becomes effective after the printer is turned off and then on again.
Values:
System Settings
Use System Settings to configure a variety of printer features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Power Saver Timer
Purpose:
To specify the time for transition to Power Saver mode.
Values:
Select 1min (default) for Low Power Timer if your printer shares an electrical circuit with your room lights and you
notice them flickering. Otherwise, select a high value to keep your printer available for frequent use with the
minimum warm-up time.
The printer automatically returns to the standby mode from the Power Saver mode when it receives data from the
computer or remote fax machine. You can also change the status of the printer to the standby mode by pressing the
(Energy Saver) button on the operator panel.
• Power Saver Wake Up
Purpose:
To specify whether to wake up from the Low Power or Sleep mode when OnHook is set to Off.
Values:
Auto Sets the PostScript communications protocol automatically.
Standard Sets the PostScript communications protocol to Standard.
BCP Sets the PostScript communications protocol to BCP.
TBCP* Sets the PostScript communications protocol to TBCP.
Binary Sets the PostScript communications protocol to Binary.
Low Power
Timer
1min
*
Specifies the time taken by the printer to enter Low Power mode after
it finishes a job.
1–60
Sleep Timer 1min
*
Specifies the time taken by the printer to enter Sleep mode after it has
entered Low Power mode.
1–60
OffHook Wake Up Off
*
Does not wake up from the Low Power or Sleep mode when OnHook
is set to Off.
On Wakes up from the Low Power or Sleep mode when OnHook is set to
Off.