230 Faxing
Confirming Transmissions
When the last page of your document has been sent successfully, the printer beeps and returns to the standby
mode.
If something goes wrong while sending your fax, an error message appears on the LCD panel.
If you receive an error message, press the button to clear the message and try to send the document again.
You can set your printer to print a confirmation report automatically after each fax transmission.
See also:
• "Printing a Report Page" on page 250
Automatic Redialing
If the number you have dialed is busy or there is no answer when you send a fax, the printer will automatically redial
the number every minute based on the number set in the redial settings.
To change the time interval between redials and the number of redial attempts, see "Available Fax Settings Options"
on page 246.
NOTE:
• The printer will not automatically redial a number that was busy when the number was manually entered.
To Next Page
Loading...
Need help?
General
